Electrical Upgrades
A new kitchen with the old two outlets is not an improvement. We plan light and power with the room, then keep the workmanship tidy and labeled.
We begin with how you use the room after dark. Task light on a counter, a soft source over a table, a path light for a hallway, and a switch where your hand actually lands when you enter. Pretty fixtures are chosen after those jobs are clear.
Older homes often ask a single circuit to do too much. A bath fan, a kettle, and a heater should not share a tired line. Where a renovation adds load, we plan dedicated circuits and say what the panel can still accept. If the panel itself is at the end of its life, that conversation happens before the fixture order, not after the walls are closed.
Devices are set plumb, at consistent heights, and with plates that match the finish of the room. We protect finished floors while we work and patch the openings we make. Cable is supported, boxes are not buried, and the directory on the panel is updated so the next person is not guessing.
We coordinate with the other trades. The tile setter needs to know where a niche light sits. The cabinet maker needs the outlet above the counter, not behind a drawer. Those marks are on the drawing before the first hole.
- Lighting planned for tasks, not only for photographs
- Circuit load discussed before new appliances arrive
- Devices aligned and the panel directory updated
- Coordination with cabinetry, tile, and paint
Questions households ask
We can. A like-for-like fixture swap is a small scope. If the box, the switch loop, or the circuit is not sound, we enlarge the conversation before we hang something new on it.
Often, from an attic or with a careful opening that is patched and painted. If access does not exist, we show you the tradeoff before cutting.
They are wonderful on the right lamp and a buzz on the wrong driver. We match the control to the fixture so the room dims instead of flickers.
Yes. A renovation that adds circuits and leaves a blank directory is unfinished.